Siemens SCALANCE XR-300WG - No Switchport Private-Vlan Host-Association

Requirement
● The interface is configured as a host port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport private-vlan host-association <primary-vlanId(1-4094)>
<secondary-vlanId(1-4094)>
The parameters have the following meaning:
Parameter Description Range of values / note
primary-vlanId VLAN ID of the primary PVLAN 1 ... 4094
secondary-vlanId VLAN ID of the secondary PVLAN 1 ... 4094
Result
The interface is configured.
Further notes
You delete the configuration with the command.
You display this setting and other information with the commands show vlan port
config, show vlan and show vlan private-vlan.
You configure the interface as a host port with the command.
6.1.3.13 no switchport private-vlan host-association
Description
With this command, you delete the configuration of a host port.
Requirement
● The interface is configured as a host port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
188 Configuration Manual, 07/2017, C79000-G8976-C361-06