Siemens SCALANCE XR-300WG - No Ip Igmp Snooping Static-Group

8.2.3.2 no ip igmp snooping static-group
Description
With this command, you delete a static IGMP entry.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip igmp snooping static-group <mcast_addr>
The parameter has the following meaning:
Parameter Description Range of values / note
static-group Keyword for a static entry -
mcast_addr Value for a multicast address Enter a valid multicast address.
Result
The static IGMP entry has been deleted.
Further notes
You create a static IGMP entry with the ip igmp snooping static-group command.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
386 Configuration Manual, 07/2017, C79000-G8976-C361-06