Requirement
● Loop detection is enabled.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no loopd reaction local
Result
"no action" is activated for the loopd reaction local function.
"disable" is the default after enabling loop detection.
Further notes
You enable the "disable" reaction with the loopd reaction local command.
You can display the status of this function and other information with the show loopd command.
See also
Addresses and interface names (Page 36)
12.6.3.7 loopd reaction remote
Description
With this command, you enable the "disable" reaction for a remote loop. If a remote loop is
detected, the port is blocked.
Requirement
● Loop detection is enabled.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
loopd reaction remote
Diagnostics
12.6 Loop detection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
608 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
