EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Storm-Control Level

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no storm-control{broadcast|multicast|dlf}
The parameters have the following meaning:
Parameter Description
broadcast Disables broadcast storm control
multicast Disables multicast storm control
dlf Disables unknown unicast storm control
if you call up the function without parameters, it is disabled for all types of transmission.
Result
The storm control function is disabled.
Further notes
You enable the function with the storm-control command.
10.1.2.5 storm-control level
Description
With this command, you configure the value for the storm control function in Kbps.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
storm-control level <rate-value>
Load control
10.1 Rate control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
458 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals