3.1.10.8 no lldp
Description
With this command, you disable the sending or receipt of LLDP packets on the interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no lldp{transmit|receive}
The parameters have the following meaning:
Parameter Description
transmit the sending of LLDP packets is disabled
receive the receipt of LLDP packets is disabled
Note
Disabling both options
When you call this command, you can only select one option.
If you want to disable both options, call up the command again.
Result
Sending or receipt of LLDP packets is disabled.
Further notes
You enable the sending or receipt of LLDP packets with the lldp command.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 81
To Next Page
Loading...
