Siemens SCALANCE XR-300WG - No Dcp Server; Commands in the Interface Configuration Mode

Result
The read and write permissions for the DPC server are configured.
The DCP server is enabled.
Further notes
You disable the DCP server with the no dcp server command.
7.1.2.8 no dcp server
Description
With this command, you disable the DCP server.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no dcp server
Result
The DCP server is disabled.
Further notes
You enable and configure the DCP server with the dcp server command.
7.1.3 Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the interface command to change to this mode.
Network protocols
7.1 IPv4 protocol
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 277