EasyManua.ls Logo

Siemens SCALANCE XR-300WG - No Standby Force-Master; Standby Port

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Further notes
You disable the setting with the no standby force-master command.
You can display the status of this function and other information with the show ring-
redundancycommand.
8.4.6.7 no standby force-master
Description
With this command, you disable the standby force-master function.
Requirement
HRPis enabed
You are in the Redundancy configuration mode.
The command prompt is:
cli(config-red)#
Syntax
Call the command without parameters:
no standby force-master
Result
The standby force-master function is disabled.
Further notes
You enable the setting with the standby force-master command.
You can display the status of this function and other information with the show ring-
redundancycommand.
8.4.6.8 standby port
Description
With this command, you configure and enable the port for a standby connection on a device.
Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 405

Table of Contents

Related product manuals