Further notes
You can reset the setting to the default with the no smtp-port command.
You display the setting with the show smtp-port command.
7.6.2.7 no smtp-port
Description
With this command, you reset the SMTP port to the default.
The default value is 25.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
no smtp-port
Result
The SMTP port is reset to the default value.
Further notes
You configure the setting with the smtp-port command.
You display the setting with the show smtp-port command.
Network protocols
7.6 SMTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 357
To Next Page
Loading...
