Siemens SCALANCE XR-300WG - No Negotiation

Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
negotiation
Result
The automatic negotiation of connection parameters on an interface is activated.
Further notes
You disable the autonegotiation of connection parameters with the no negotiation
command.
3.1.10.13 no negotiation
Description
With this command, you disable autonegotiation of connection parameters on an interface.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no negotiation
Result
The automatic negotiation of connection parameters on an interface is deactivated.
Further notes
You enable the autonegotiation of connection parameters with the negotiation command.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 85