Siemens SCALANCE XR-300WG - No Dot1 X Port-Control

Result
The port control parameter is configured.
Further notes
You can reset the port control parameter to the default with the no dot1x port-control
command.
You can display the status of this function and other information with the show
dot1xcommand.
11.5.3.14 no dot1x port-control
Description
With this command, you reset the port control parameter of the authenticator to the default
value.
The default value is force-authorized.
With this, data traffic is permitted without restrictions.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x port-control
Result
The port control parameter of the authenticator is reset to the default value.
Further notes
You configure the port control parameter with the dot1x port-control command.
You can display the status of this function and other information with the show
dot1xcommand.
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
538 Configuration Manual, 07/2017, C79000-G8976-C361-06