Siemens SCALANCE XR-300WG - Show Mac-Address-Table Dynamic Unicast

If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The dynamic multicast MAC addresses are displayed.
6.1.1.4 show mac-address-table dynamic unicast
Description
This command shows the table with the dynamic unicast MAC addresses assigned by the
device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show mac-address-table dynamic unicast[vlan<vlan-range>]
[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>
<interface-id>}]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN connection -
vlan-range Number of the addressed VLAN 1 ... 4094
Enter the range limits with a hy‐
phen without spaces.
address Keyword for a MAC address -
aa:aa:aa:aa:aa:aa MAC address -
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 165