Result
The settings for Layer 2 Gateway Port (L2GP) are displayed.
6.3.1.7 show spanning-tree mst
Description
This command shows various settings of the spanning tree configuration specific to a Common
Internal Spanning Tree (CIST) instance or a selected instance of the Multiple Spanning Tree
Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst[<instance-id(1-64|4094)>][detail]
The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the instance or range of in‐
stances whose settings are displayed
● 1 ... 64
● 4094
detail Shows detailed information about the
selected interface
-
Result
The settings for the spanning tree configuration are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-
tree command.
6.3.1.8 show spanning-tree mst configuration
Description
This command shows various settings for an instance of the Multiple Spanning Tree Protocol.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 223
To Next Page
Loading...
