Requirement
● IGMP snooping is enabled on the device
● You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip igmp snooping forwarding-database [Vlan<vlan id>]
The parameters have the following meaning:
Parameter Description Range of values / note
Vlan Keyword for a VLAN connection -
vlan id Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The multicast forwarding entries are displayed.
8.2.1.3 show ip igmp snooping globals
Description
This command shows an overview of the settings of IGMP snooping.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Syntax
Call the command without parameter assignment:
show ip igmp snooping globals
Result
The settings are displayed.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
376 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General