Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
name <vlan-name>
The parameter has the following meaning:
Parameter Description Range of values / note
vlan-name Name that will be assigned to the VLAN max. 32 characters
Result
The VLAN is assigned a name.
Further notes
You delete name assignment for a VLAN with the no name command.
6.1.4.2 no name
Description
With this command, you delete the name assignment for a VLAN.
Requirement
You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
no name
Result
The name of the VLAN is deleted.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 193
To Next Page
Loading...
