10.1 Rate control
This section describes commands for controlling and restricting the data transmission rate of
an interface.
10.1.1 The "show" commands
This section describes commands with which you display various settings.
10.1.1.1 show rate-limit output
Description
This command shows the packet rate for limiting the outgoing data stream of one or all
interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show rate-limit output[interface<interface-type><interface-id>]
The parameters have the following meaning:
Parameter Description Range of values / note
interface Keyword for a an interface description -
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available interfaces.
Result
The entries are displayed.
Load control
10.1 Rate control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
454 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General