8.2.2.4 ip igmp snooping clear counters
Description
With this command, you delete the counters for all or a selected VLAN.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping clear counters [Vlan <vlanid (1-4094)>]
The parameters have the following meaning:
Parameter Description Range of values / note
Vlan Keyword for a VLAN connection -
vlanid Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If you do not select a VLAN, the counters of all VLANs will be deleted.
Result
The counters are deleted.
8.2.2.5 ip igmp snooping switch-ip
Description
With this command, you configure the IP address of the source for IGMP snooping queries.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
382 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
