Further notes
You enable this function with the rmon command.
You can display the status of this function and other information with the show rmon command.
12.4.2.3 rmon alarm
Description
With this command, you configure an alarm for monitoring a MIB variable. The variable is
checked at specific intervals to determine whether or not it has exceeded or fallen below
threshold values. Events are assigned to these occurrences.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
rmon alarm <alarm-number><mib-object-id(255)>
<sample-interval-time(1-65535)>
{absolute|delta}
rising-threshold<value(0-2147483647)>[risingevent-
number(1-65535)]
falling-threshold<value(0-2147483647)>[fallingevent-
number(1-65535)]
[owner<ownername(127)>]
The parameters have the following meaning:
Parameter Description Range of values / note
alarm-number Number of the alarm 1 ... 250
mib-object-id OID of the MIB tag to be monitored max. 255 characters
sample-interval-
time
Interval for the check [s] 1 ... 65535
absolute The current absolute value of the moni‐
tored MIB is evaluated
-
delta The difference between the current and
the previous value of the monitored MIB
is evaluated
-
rising-threshold Keyword for threshold value for rising or
high variable values
-
value Relevant threshold value 0 ... 2147483647
Diagnostics
12.4 RMON
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 579
To Next Page
Loading...
Need help?
General