Siemens SCALANCE XR-300WG - No Private-Vlan

The parameters have the following meaning:
Parameter Description Range of values / note
primary With this type, you define a primary PVLAN.
The primary PVLAN uses the VLAN ID of the VLAN.
-
isolated With this type, you define a secondary PVLAN.
Devices within an isolated secondary PVLAN cannot
communicate with each other via layer 2. The sec‐
ondary PVLAN has a specific VLAN ID.
-
community With this type, you define a secondary PVLAN.
The devices in this secondary PVLAN can commu‐
nicate with each other via layer 2. The secondary
PVLAN has a specific VLAN ID.
-
Result
The PVLAN is defined and the PVLAN type specified.
Further notes
You delete the configuration as a private VLAN with the no private-vlan command.
You display this setting with the show vlan private-vlan command.
6.1.4.10 no private-vlan
Description
With this command, you delete the configuration as a private VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no private-vlan
Result
The VLAN is not a private VLAN.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 201