Siemens SCALANCE XR-300WG - No Dot1 X Mac-Auth; Dot1 X Mac-Auth Port Reset

Further notes
You also still need to enable MAC authentication for the device. You do this with the dot1x
mac-auth command in the Global configuration mode.
You disable the function with the no dot1x mac-auth command.
You display this setting and other information with the show dot1x command.
11.5.3.8 no dot1x mac-auth
Description
With this command, you disable MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no dot1x mac-auth
Result
MAC authentication is disabled for a port.
Further notes
You enable the function with the dot1x mac-auth command.
You display this setting and other information with the show dot1x command.
11.5.3.9 dot1x mac-auth port reset
Description
With this command, you reset MAC authentication for a port.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
Security and authentication
11.5 Port Based Network Access Control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
534 Configuration Manual, 07/2017, C79000-G8976-C361-06