10.5.1.4 show qos cos-remap
Description
For individual ports, this command shows the priority with which frames are sent.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show qos cos-remap
Result
The assignment table for send priority is displayed.
Further notes
You enable the the Cos reassignment with the cos-remap-enable command.
You change the priority with which frames are sent cos-remapcommand.
10.5.1.5 show qos dscp-map
Description
This command shows the assignment table of DSCP priorities to queues.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show qos dscp-map
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 481
To Next Page
Loading...
Need help?
General