The parameters have the following meaning:
Parameter Description Range of values / note
aa:aa:aa:aa:aa:aa MAC address of the interface -
vlan Keyword for the number of a VLAN con‐
nection
-
vlan-id Number of the addressed VLAN 1 ... 4094
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The entry is deleted from the forwarding database.
Further notes
With the show mac-address-table static multicast command, you display the list
of configured entries.
With the mac-address-table static multicast command, you create an entry.
10.2.1.3 mac-address-table static unicast
Description
With this command, you generate a static unicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static unicast <aa:aa:aa:aa:aa:aa>
vlan <vlan-id(1-4094)>
interface ([<interface-type> <interface-id>]
[<interface-type> <0/a-b, 0/c,...>]
[port-channel <interface-list>])
Load control
10.2 Static MAC filtering
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 463
To Next Page
Loading...
Need help?
General