Siemens SCALANCE XR-300WG - No Ip Dhcp Relay Circuit-ID; Ip Dhcp Relay Remote-ID

Result
The Circuit ID is assigned.
Further notes
You remove the Circuit ID with the no ip dhcp relay circuit-id command.
You display the IP addresses with the show dhcp server command.
You display the settings with the show ip dhcp relay information command.
7.4.3.2 no ip dhcp relay circuit-id
Description
With this command, you remove the Circuit ID.
Requirement
● The interface is an IP interface.
● You are in the Interface Configuration mode of VLAN. The command prompt is as follows:
cli(config-if-vlan-$$)#
Syntax
Call the command without parameter assignment:
no ip dhcp relay circuit-id
Result
The Circuit ID is removed.
Further notes
You configure the Circuit ID with the ip dhcp relay circuit-id command.
You display the IP addresses with the show dhcp server command.
You display the settings with the show ip dhcp relay information command.
7.4.3.3 ip dhcp relay remote-id
Description
With this command, you specify the device ID.
Network protocols
7.4 DHCP Relay
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 319