Result
The global information is displayed.
6.1.1.9 show vlan learning params
Description
This command shows the parameters for the automatic learning of addresses for selected or
all VLANs (active and inactive VLANs).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show vlan learning params[vlan<vlan-range>]
The parameters have the following meaning:
Parameter Description Range of values / note
vlan Keyword for a VLAN or VLAN range -
vlan-range Number of the addressed VLAN or
VLAN range
1 ... 4094
Enter the range limits with a hy‐
phen or a space.
If you do not select any parameter from the parameter list, the entries of all available interfaces
are displayed.
Result
The settings for the automatic learning of addresses are displayed.
6.1.1.10 show vlan port config
Description
This command shows the VLAN-specific information for ports.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 169
To Next Page
Loading...
