5.3 SNTP client
This section describes commands relevant for configuration of the SNTP client.
5.3.1 The "show" commands
This section describes commands with which you display various settings.
5.3.1.1 show sntp broadcast-mode status
Description
This command shows the current configuration of the broadcast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show sntp broadcast-mode status
Result
The current SNTP broadcast configuration is displayed.
5.3.1.2 show sntp unicast-mode status
Description
This command shows the current configuration of the unicast mode of SNTP.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
System time
5.3 SNTP client
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
154 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
