EasyManua.ls Logo

Siemens SCALANCE XR-300WG - No Ip Nat Service Portrange

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9.1.3.10 no ip nat service portrange
Description
With this command you delete static port translations (NAPT) for an interface with a port range.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat service portrange <inside local ip> {tcp|udp|any} <inside
local start port no> <inside local end port no>
The parameters have the following meaning:
Parameter Description Range of values / note
inside local ip Actual address of the device that is
reachable from external.
Enter a valid IPv4 address.
Protocol Protocol for which the port translation is
valid.
tcp
udp
any
inside local
start port no
Start port that is assigned to the inside
local address.
-
inside local end
port no
End port that is assigned to the inside
local address.
-
Result
The static port translation with a port range is deleted.
Further notes
You configure static port translations for an interface with a port range with the ip nat
service portrange command.
You configure static port translations with a service for an interface with the ip nat
service command.
You display the current configuration with the show ip nat service portrange
command.
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 447

Table of Contents

Related product manuals