The parameters have the following meaning:
Parameter Description Range of values / note
instance-id Number of the instance or range of in‐
stances whose settings are displayed
● 1 ... 64
● 4094
interface-type Type or speed of the interface Enter a valid interface
interface-id Module no. and port no. of the interface
stats Shows the number of incoming and out‐
going packets for each path of the inter‐
face
-
hello-time Shows the intervals at which the root
switch sends its "Hello" message to the
other switches
-
detail Shows detailed information about the
selected interface
-
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The port-specific settings are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-
tree command.
6.3.1.10 show spanning-tree passive-listening-compatibility
Description
This command shows whether or not the "Enhanced Passive Listening Compatibility" function
is enabled or disabled.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show spanning-tree passive-listening-compatibility
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 225
To Next Page
Loading...
Need help?
General