Result
The details of the SNMP user are configured.
Further notes
You delete the settings with the no snmp user command.
You display the configured users with the show snmp user command.
7.5.2.21 no snmp user
Description
With this command, you delete the details of an SNMP user.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp user <UserName>
The parameter has the following meaning:
Parameter Description Range of values / note
UserName Name of the user max. 32 characters
Result
The details of the SNMP user are deleted.
Further notes
You change the settings with the snmp user command.
You display the configured users with the show snmp usercommand.
7.5.2.22 snmp view
Description
With this command, you configure an SNMP view.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
348 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General