Requirement
● An SNMP group has been created
● The access to the group is configured with snmp access
● You are in the Global Configuration mode.
The command prompt is:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp view <ViewName> <OIDTree> [mask<OIDMask>] {included|excluded}
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter Description Range of values / note
ViewName Name of the SNMP view max. 32 characters
OIDTree Object ID Path information of the MIB tree
mask Keyword for the OID mask -
OIDMask Mask that filters access to the elements
of the MIB tree
A series of "0" and "1" separated
by dots in keeping with the path in‐
formation of the MIB tree
View type Specifies whether the filtered elements
are used or excluded.
● included (Default)
● excluded
Storage type Specifies whether the settings remain
following a restart.
● volatile:
The settings are lost after a
restart
● nonvolatile:
The settings are retained after
a restart (default).
If optional parameters are not specified when configuring, the default values apply.
Result
The SNMP view is configured.
Further notes
You delete the view with the no snmp view command.
You display the configured SNMP tree views with the show snmp viewtree command.
You display the SNMP group access rights with the show snmp group access command.
You configure the SNMP group access rights with the snmp access command.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 349
To Next Page
Loading...
Need help?
General