Further notes
You change the priority with the prioritycommand.
You enable the priority with the priority-enable command.
You disable the priority with the no priority-enable command.
You display the current priority with the show vlan command.
You configure the assignment of the priority to a queue with the cos-map command.
6.1.4.7 priority-enable
Description
With this command, you enable the priority of a VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
priority-enable
Result
The priority of the VLAN is enabled.
Further notes
You disable the priority with the no priority-enable command.
You change the priority with the prioritycommand.
You reset the priority to the default value with the no priority command.
You display the current priority with the show vlan command.
6.1.4.8 no priority-enable
Description
With this command, you disable the priority of a VLAN.
Network structures
6.1 VLAN
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 199