10.2 Static MAC filtering
This section describes commands for filtering data packet on an interface.
With the following commands, note which "Base bridge mode" you are in. If you are in the
"Transparent Bridge" mode, all settings relate to the management VLAN: VLAN 1.
You change the mode with the base bridge-mode command.
10.2.1 Commands in the global configuration mode (VLAN bridge)
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
10.2.1.1 mac-address-table static multicast
Description
With this command, you generate a static multicast MAC address entry in the forwarding
database.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
mac-address-table static multicast <aa:aa:aa:aa:aa:aa>
vlan<vlan-id(1-4094)>
interface([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/a-b,0/c,...>]
[port-channel<1-8>]])
[forbidden-ports([<interface-type><0/a-b,0/c,...>]
[<interface-type><0/ab,0/c, ...>]
[port-channel <1-8>]])
Load control
10.2 Static MAC filtering
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 461
To Next Page
Loading...
Need help?
General