3.1.9.1 interface
Description
With this command, you change to the Interface configuration mode.
There you can edit the settings for one interface. You select the interface with the parameters
of this command. If you specify a logical interface that does not exist, it will be created. The
name of the selected interface is displayed in the command prompt.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
interface {vlan<vlan-id(1-4094)>|port-channel<port-channel-id(1-8)>|
<interface-type><interface-id>}
The parameters have the following meaning:
Parameter Description Values
vlan Keyword for a VLAN connection -
vlan-id Number of the addressed VLAN 1 … 4094
port-channel Keyword for a port channel connection -
port-channel-id Number of the addressed port channel 1 … 8
interface-type Type or speed of the interface Enter a valid interface.
interface-id Module no. and port no. of the interface
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder $$$ is replaced by the following name of the interface:
Type of interface Command prompt
port-channel cli(config-if-po-$)#
vlan cli(config-if-vlan-$)#
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 65
To Next Page
Loading...
Need help?
General