EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Spanning-Tree Layer2-Gateway-Port

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Syntax
Call up the command with the following parameters:
spanning-tree bpdufilter{disable|enable}
The parameters have the following meaning:
Parameter Description Range of values / note
disable The transfer of BPDU packets is disa‐
bled for the port
Default: disabled
enable The transfer of BPDU packets is ena‐
bled for the port
-
Result
The BPDU transmit status is configured.
6.3.5.8 spanning-tree layer2-gateway-port
Description
With this command, you configure a port as a layer 2 gateway port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
spanning-tree layer2-gateway-port
Result
The port is configured as a layer 2 gateway port.
Further notes
You delete the configuration of a port as a layer 2 gateway port with the commandno
spanning-tree layer2-gateway-port.
You can display other information with the show spanning-tree interface command
with the detail option.
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
248 Configuration Manual, 07/2017, C79000-G8976-C361-06

Table of Contents

Related product manuals