EasyManua.ls Logo

Siemens SCALANCE XR-300WG - Show Device Information; Show Environmental Temperature

Siemens SCALANCE XR-300WG
618 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Syntax
Call the command without parameters:
show coordinates
Result
The system coordinates are displayed.
3.1.1.3 show device information
Description
This command shows information about the device.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
show device information
Result
The information about the device is displayed.
3.1.1.4 show environmental temperature
Description
This command shows the temperature values of internal and external modules of the device.
The modules are only shown if they make temperature information available.
If the temperature value falls below or exceeds the displayed threshold values, the status
changes accordingly. With the event config command, you can configure that you are
informed of the status change by a message.
Requirement
You are in the Privileged EXEC mode.
The command prompt is as follows:
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 49

Table of Contents

Related product manuals