Siemens SCALANCE XR-300WG - No Ring-Redundancy Hrpobserver; Ring-Redundancy Mode

Further notes
You disable the observer with the no ring-redundancy hrpobserver command.
You can display the status of this function and other information with the show ring-
redundancy command.
8.4.5.3 no ring-redundancy hrpobserver
Description
With this command, you disable the observer.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ring-redundancy hrpobserver
Result
The observer is disabled.
Further notes
You enable the observer with the ring-redundancy hrpobserver command.
You can display the status of this function and other information with the show ring-
redundancy command.
8.4.5.4 ring-redundancy mode
Description
With this command, you enable the ring redundancy function on a device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
Layer 2 management protocols
8.4 Ring redundancy and standby connection
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
396 Configuration Manual, 07/2017, C79000-G8976-C361-06