Parameter Description Range of values / note
port Keyword for the port of the server via
which the TFTP connection runs
-
tcp port Number of the port 1 … 65535
Default: 69
file Keyword for a file name to be assigned -
filename Name of the file max. 100 characters
filetype Keyword for the file type to be loaded -
filetype Name of the file type max. 100 characters
For information on identifiers of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The file is loaded on the device from the TFTP server.
Further notes
With the "show loadsave files" command, you can display the file types.
3.2.4 save filetype
Description
With this command, you save files on a TFTP server.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
save filetype <filetype> tftp ipv4 <ipv4-address> [port <tcp port
(1-65535)>] file <filename>
The parameters have the following meaning:
Parameter Description Range of values / note
filetype Keyword for a file type to be loaded -
filetype Name of the file type max. 100 characters
tftp Keyword for a TFTP server -
Configuration
3.2 Load and Save
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 93
To Next Page
Loading...
Need help?
General