7.3.2.1 ip dhcp-server
Description
With this command, you enable the DHCP server on the device.
Note
To avoid conflicts with IPv4 addresses, only one device may be configured as a DHCP server
in the network.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server
Result
The DHCP server is enabled.
Further notes
You disable the DHCP server with the no ip dhcp-server command.
7.3.2.2 no ip dhcp-server
Description
With this command, you disable the DHCP server on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
290 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
