Siemens SCALANCE XR-300WG - No Cos-Remap-Enable

Syntax
Call the command without parameters:
cos-remap-enable
Result
The CoS reassignment function is enabled.
Further notes
You disable the function with the no cos-remap-enable command.
You change the priority with which frames are sent with the cos-remap command.
You reset the send priority to the default value with the no cos-remap command.
You display the assignment table for the send priority with the show qos cos-remap
command.
10.5.3.9 no cos-remap-enable
Description
With this command, you disable the CoS reassignment function.
Requirement
You are in the QOS configuration mode.
The command prompt is as follows:
cli(config-qos)#
Syntax
Call the command without parameters:
no cos-remap-enable
Result
The CoS reassignment function is disabled.
Further notes
You enable the function with the cos-remap-enable command.
You change the priority with which frames are sent with the cos-remap command.
You reset the send priority to the default value with the no cos-remap command.
Load control
10.5 Service classes
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 491