Note
Output in pages
With long lists, the results are displayed as pages. If -- more -- appears at the lower edge
of the display, you can move to the next page with the spacebar. If the display is in pages, you
cannot page back. You exit the page display with the q key.
2.9.4.3 Completion of command entries
Description
The command interpreter of the Command Line Interface supports you when you enter
commands.
As soon as the first characters of the command have been entered in the input line, the system
can complete the entry as long as the character string is unambiguous.
This can be repeated after entering further characters.
Procedure
Enter the first characters of the command.
Press the tab key.
Result
The command interpreter completes the input as long as the command is unambiguous.
If you enter a character string that cannot be completed to form a command, an error message
is displayed.
● The command is not unique: % Ambiguous Command
● The command is unknown: % Invalid Command
● The command is incomplete: % Incomplete command
If the entry is not yet complete, enter further characters.
With ?, you obtain a list of the possible commands.
Repeat this if necessary until the command is complete and can execute.
2.9.4.4 Abbreviated notation of commands
Description
The command interpreter of the Command Line Interface also detects commands if only the
first character of the command or its parts is entered.
General information
2.9 General CLI commands
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
42 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General