The parameters have the following meaning:
Parameter Description
10 Transmission speed 10 Mbps
100 Transmission speed 100 Mbps
Result
The transmission speed of the interface is configured.
3.1.10.17 unicast-block
Description
With this command, you enable the blocking of unknown unicast frames on an interface.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
unicast-block
Result
Unicast frames are blocked.
Further notes
You disable the blocking of unicast frames with the no unicast-block command.
You display the status of this function with show unicast-block config.
3.1.10.18 no unicast-block
Description
With this command, you disable the blocking of unknown unicast frames on an interface.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
88 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
