Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no unicast-block
Result
The blocking of unicast frames is disabled.
Further notes
You enable the blocking of unicast frames with the unicast-block command.
You display the status of this function with show unicast-block config.
Configuration
3.1 System
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 89
To Next Page
Loading...
