7.5.2.1 snmpagent
Description
With this command, you enable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
snmpagent
Result
The SNMP agent function is enabled.
Further notes
You disable the SNMP agent function with theno snmpagent command.
7.5.2.2 no snmpagent
Description
With this command, you disable the SNMP agent function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no snmpagent
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
330 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
