Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
storm-control{broadcast|multicast|dlf}
The parameters have the following meaning:
Parameter Description
broadcast Limits broadcast packets
multicast Limits multicast packets
dlf Limits unicast packets with unresolvable addresses
(dfl = destination lookup fail)
As default the function is "disabled" for all transfer types.
Note
Configuration of the threshold value
The default value for the storm control level is 0 Kbps. The incoming data stream is not limited.
To have the incoming data stream limited, configure the threshold value with the storm-
control level command.
Result
The storm control function is enabled.
Further notes
You enable the function with the no storm-controlcommand.
You configure the threshold value for the storm control function with the storm-control
level command.
10.1.2.4 no storm-control
Description
With this command, you disable the storm control function for broadcast, multicast or unknown
unicast packets.
Load control
10.1 Rate control
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 457
To Next Page
Loading...
