cli(config-dhcp-pool-<ID>)#
Syntax
Call up the command with the following parameters:
network <lower-IP> <upper-IP> { <subnet-mask> | / <prefix-length
(1-32)> }
The parameters have the following meaning:
Parameter Description Range of values / note
lower-IP Start of the IPv4 address band Enter a valid IPv4 address.
upper-IP End of the IPv4 address band Enter a valid IPv4 address.
subnet-mask Subnet mask of the corresponding
subnet
Enter a valid subnet mask.
prefix-length Decimal representation of the
mask as a number of "1" bits
1 ... 32
Result
The IPv4 address band is configured. The DHCP options 1, 3, 6, 66 and 67 are created
automatically. With the exception of option 1, the options can be deleted.
Further notes
You display the setting with the show ip dhcp-server pools command.
You assign an IP address to an interface with the set interface command.
You configure the DHCP option 67 with the option value-string command.
You configure the DHCP options 3, 6 and 66 with the option command.
You delete the DHCP option with the no option command.
7.3.3.3 Option (IP address)
Description
With this command you configure the DHCP options 3 and 6 that contain an IPv4 address as
DHCP parameter. The DHCP options 3 and 6 are created automatically when the IPv4 address
band is created.
Requirement
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Network protocols
7.3 DHCP server
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
296 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General