Siemens SCALANCE XR-300WG - Ip Igmp Snooping Port-Purge-Interval

Syntax
Call up the command with the following parameters:
ip igmp snooping switch-ip<switch-ipaddr>
The parameter has the following meaning:
Parameter Description Range of values / note
switch-ipaddr Address of the source Specify a valid IP address.
Default: 10.0.0.1
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
Result
The IP address is configured.
8.2.2.6 ip igmp snooping port-purge-interval
Description
The time after which a port is deleted from the list if no IGMP router control packets are received
is known as the purge time.
With this command, you configure this purge time for a port for a VLAN in seconds.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping port-purge-interval <(130-1225)seconds>
The parameters have the following meaning:
Parameter Description Range of values / note
- Value for the purge time in seconds 130 ... 1225
Default: 300
Result
The purge time is configured.
Layer 2 management protocols
8.2 IGMP snooping
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 383