Parameter Description Range of values
Seconds Time in seconds 1 ... 1500
retries Keyword for the maximum number of
attempts to obtain a response to an
inform request message
-
RetryCount Number of attempts 1 ... 3
taglist Keyword for tag list -
TagIdentifier Tag identifier that selects the target
address for SNMP.
Specify the tag identifier.
none No tag identifier -
Storage Type Specifies whether the settings re‐
main following a restart.
● volatile:
The default settings are used
after a restart.
● nonvolatile:
The saved settings are used after
a restart.
port Keyword for the port number at which
the SNMP manager receives traps
and inform messages
-
integer Port number 1 ... 65535
For information on names of addresses and interfaces, refer to the section "Addresses and
interface names (Page 36)".
If optional parameters are not specified when configuring, the following defaults apply:
Parameter Default value
taglist snmp
Storage Type volatile
port 162
Result
The SNMP target address is configured.
Further notes
You delete the SNMP target address with the no snmp targetaddr command.
You display the SNMP target address with the show snmp targetaddr command.
You configure the SNMP target parameters with the snmp targetparams command.
You display the SNMP target parameters with the show snmp targetparam command.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
342 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
Need help?
General