Siemens SCALANCE XR-300WG - Page 332

The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
snmp access <GroupName> {v1|v2c|v3 {auth|noauth|priv}}
[read <ReadView|none>][write <WriteView|none>][notify <NotifyView|
none>]
[{volatile|nonvolatile}]
The parameters have the following meaning:
Parameter Description Range of values / note
GroupName Name of the group to which access is
configured
max. 32 characters
Version Selects the version of the protocol used
● v1
● v2c
● v3
Authentication Selects the authentication method.
● auth
Enables MD5 or SHA as
authentication method
● noauth
No authentication
● priv
Enables authentication and
encryption
read The data can be read.
Keyword
● ReadView
● none
write The data can be read and written
Keyword
● WriteView
● none
notify Changes can be sent as a tag.
Keyword
● NotifyView
● none
Storage Type Specifies whether the settings remain
following a restart.
● volatile :
The settings are lost after a
restart
● nonvolatile :
The settings are retained after
a restart
The keywords need to be specified.
If optional parameters are not specified when configuring a group, the default value will be
used.
Result
The settings for access to an SNMP group are configured.
Network protocols
7.5 SNMP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
332 Configuration Manual, 07/2017, C79000-G8976-C361-06