Siemens SCALANCE XR-300WG - Page 244

Parameter Default value
link-type
● point-to-point
The connection is configured as full-duplex
● shared
in all other cases
portfast disabled
port-priority 128
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree {cost|disable|link-type|portfast|port-priority}
The parameters have the following meaning:
Parameter Description
cost Keyword for the costs of the port for calculating the lowest-cost path.
disable Enables the interface for spanning tree.
link-type Connection status of the following network segment
portfast Disables the PortFast function.
port-priority Keyword for the priority of the interface
Note
Configure multiple properties
With each call of the command, you can configure precisely one property.
If you want to configure several properties, call the command several times.
Result
The selected setting was reset to the default value.
Further notes
You configure the setting with the spanning-tree command (properties).
You display these settings and other information with the commands that start with show
spanning tree ....
Network structures
6.3 Spanning Tree
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
244 Configuration Manual, 07/2017, C79000-G8976-C361-06