Requirement
You are in the Global configuration mode
or
You are in the Interface configuration mode
The command prompt is as follows:
cli(config)#
cli (config-if-$$$) #
Syntax
Call the command without parameters:
no gvrp
Result
In the Global configuration mode: The GVRP function is disabled on the device.
In the Interface configuration mode: The GVRP function is disabled for this interface.
Further notes
If you want to enable the function for a specific interface on the device, use the gvrp command.
You can display the status of this function and other information with the show vlan device
info command.
Layer 2 management protocols
8.1 GARP
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
374 Configuration Manual, 07/2017, C79000-G8976-C361-06
To Next Page
Loading...
