Siemens SCALANCE XR-300WG - Page 449

Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat static <inside local ip>
The parameter has the following meaning:
Parameter Description Range of values / note
inside local ip Actual address of the device that is
reachable from external.
Enter a valid IPv4 address.
Result
A static address translation is deleted.
Further notes
You configure a static address translation with the ip nat static command.
You display the current configuration with the show ip nat command.
Layer 3 functions
9.1 NAT
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 449