Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no monitor session<session-id(1-1)>
The parameter has the following meaning:
Parameter Description Range of values / note
session-id Number of the session 1
Result
The monitor session is deleted.
Further notes
You display the configuration settings with the show monitor session command.
You configure and start mirroring of a port with the monitor session command.
Diagnostics
12.5 Port Mirroring
SCALANCE XB-200/XC-200/XF-200BA/XP-200/XR-300WG Command Line Interface
Configuration Manual, 07/2017, C79000-G8976-C361-06 597
To Next Page
Loading...
